I have a new-ish sensor which I am using in stand alone mode ( so that I can move it to places out of range of the Water Mate ). Stupidly, I changed the logging interval from 15 minutes ( set when I first installed it ) to 30 minutes using the Grow Harvst web page. It very rarely sends any data now. I tried removing it and then adding it again, and the default interval as 1800 minutes ( 30 hours! ). I changed it to 30 minutes again, but it still does not send properly. The mesh node it talks to is a couple of feet away, and is the same one used by the WaterMate, which sends data regularly without any problems. I tried to set it into local server mode again to see if I could alter the settings in its own web page, but it never did show up as an access point.
As an aside, is it possible to include the time in the .csv file that is downloaded, as well as the date. I had some difficulty in sorting out the readings when I downloaded them, particularly as som appeared to have been added to the file twice.
Thank you for your speedy reply. No - that one is linked to the Watermate and behaves as expected. The one I am concerned about is 18A79B1FB608. As I write it is 10:05, and the last reading sent to the web app seems to have been at 23:40 yesterday.
Hi Chris
Your sensor has updated firmware and was reporting every 10 minutes through the early hours. It's now reporting every 30 minutes, was that you making an update?
Chris
Register for a free account and join the Harvst community.
As an aside, is it possible to include the time in the .csv file that is downloaded, as well as the date. I had some difficulty in sorting out the readings when I downloaded them, particularly as som appeared to have been added to the file twice.
Can you confirm it's sensor ACBD46DAD4D4 ?
If so, I will set it to update firmware and then we can start to look at it.
Chris
Your sensor has updated firmware and was reporting every 10 minutes through the early hours. It's now reporting every 30 minutes, was that you making an update?
Chris